Sms (Short Message Service) Operation - Alpine CDA-9820XM Owner's Manual

Retrieving an addressee by Selecting Search (A-Z search)
3
Press 8 or 9 to select an initial letter (A to Z) of the
addressee.
4
Turn the Rotary encoder to select the addressee.
5
Press :/J or Rotary encoder to place a call.
6
Press BAND/TEL. to end the call.
Telephone mode will end and return to the original source
mode.
• If all telephone numbers and registered names cannot be displayed
at once, press DISP/TITLE
names.
• "NO MEM" is displayed if nothing is registered in the Phone
Book.
Calling by using the Speed Dial
You can place a call by retrieving one of the telephone numbers
registered in No. 1 to 9 of the address book.
1
Press and hold BAND/TEL. for at least 2 seconds.
2
Within 5 seconds, place a call by pressing and
holding the desired preset buttons (1 through 6)
for at least 2 seconds.
By pressing F/SETUP, and then pressing a preset
button (1 through 3) for at least 2 seconds, you
can place a call to the number registered in 7 to 9.
• You can place a call by pressing :/J after momentarily pressing
the preset button (1 through 6) of the number you wish to call.
• You can place a call by pressing the Rotary encoder, after selecting
a number which you wish to call, by pressing g or f , or by
turning the Rotary encoder.
3
Press BAND/TEL. to end the call.
Telephone mode will end and return to the original source
mode.
• If there is no telephone number registered to a preset button, "NO
P-SET" is displayed when you try to place a call.
20
-EN
to show undisplayed numbers and
Calling by the outgoing/incoming/absent incoming history
You can place a call to any of the last 999 calls by the outgoing/
incoming/absent incoming history.
1
Press SEARCH/QS
mode to select the History mode.
2
Press 8 or 9 to select outgoing history (display
example: "DIALED"), incoming history (display
example: "RECEIVED" ), absent incoming history
(display example: "MISSED").
3
Turn the Rotary encoder, or press g or f to
select the addressee from the outgoing or
incoming history.
4
Press :/J or the Rotary encoder to place a call.
5
Press BAND/TEL. to end the call.
Telephone mode will end and return to the original source
mode.
• If all telephone numbers and registered names cannot be displayed
at once, press DISP/TITLE
names.
• "NO MEM" is displayed if there is no incoming history.

SMS (Short Message Service) Operation

You can be informed when you receive a short message.
Receiving a short message
1
When a text message is received, "NEW MSG" is
indicated on the display.
The contents of the received message can only be read
from the portable phone's display.
2
Press any one of the buttons on the unit to cancel
the display. The buttons that are pressed will enter
the mode or will be activated.
in PHONE BK (Phone Book)
to show undisplayed numbers and