Adjusting Volume/Balance (Between Left And Right)/Fader (Between Front And Rear)/Defeat; Audio Mute Function; Displaying Time; Setting Time - Alpine CDA-7892 Owner's Manual

Basic Operation
g DN
BAND MODE (Rotary encoder)
f UP
X-OVER CENTER f
Adjusting Volume/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1
Press the MODE (Rotary encoder) button repeatedly
to choose the desired mode.
Each press changes the modes as follows:
→ BALANCE → FADER → DEFEAT
SUBWOOFER*← VOLUME ←
Volume : 0 ~ 35
Balance : L15 ~ R15
Fader: R15 ~ F15
Subwoofer: 0 ~ +15
NOTES
• If the MODE button is not pressed within 5 seconds after
selecting the BALANCE, FADER, DEFEAT or SUBWOOFER
mode, the unit automatically returns to the VOLUME mode.
• *When the subwoofer mode is OFF, its level cannot be
adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of
BASS, TREBLE will return to the factory defaults, but
MX will be turned off.
NOTE
Depending on the connected devices, some functions and display
indications do not work.

Audio Mute Function

Activating this function will instantly lower the volume
level by 20 dB.
1
Press the MUTE button to activate the MUTE mode.
The audio level will decrease by about
20 dB.
Pressing the MUTE button again will bring the audio
back to its previous level.
6
-EN
CLK MUTE

Displaying Time

1
Press the CLK (clock) button repeatedly until the time
is displayed.
Each press changes the modes as follows:
Radio mode
Clock priority
→ →
Radio frequency
mode
CD Player/Changer modes
Playing time Clock priority
→ →
mode mode
TITLE mode
NOTES
• Selecting any tuner or CD function while in the clock priority
mode will interrupt the time display momentarily. The
function selected will be displayed for about 5 seconds before
the time returns to the display.
• When the power is off but the ignition key is on, press the CLK
button to display the time.
•∗ For CDA-7893/CDA-7892 models, the display above is shown
with a CD-TEXT compatible changer connected.

Setting Time

1
In the Clock priority mode, press and hold the CLK
(clock) button for at least 3 seconds while the time is
displayed. The time indication will blink.
2
Turn the Rotary encoder to adjust the hours while the
time indication is blinking.
3
When the hour has been adjusted, press the Rotary
encoder.
4
Turn the Rotary encoder to adjust the minutes while
the time indication is blinking. The time is automatically
set 5 seconds after the minute adjustment. The time
can also be manually set by pressing the Rotary
encoder.
→
TITLE mode
*
DISC TEXT
→
mode
*
TRACK
← ←
TEXT mode