Table of Contents
Advertisement
3. If the drive bay assembly was removed, align it with the two slots and rails on
4. Slide the drive bay assembly towards the rear of the chassis until it snaps into
5. Reinstall the front bezel if it was removed.
6. Position the computer cover on the chassis so that the rail guides on the sides
Figure 32. Installing the computer cover
7. Install any locking devices such as a padlock as necessary.
8. Reconnect the external cables and power cords to the computer. See "Locating
9. To update your configuration, refer to Chapter 4, "Using the Setup Utility," on
Note: In most areas of the world, Lenovo requires the return of the defective CRU.
Obtaining device drivers
You can obtain device drivers for operating systems that are not preinstalled at:
http://www.lenovo.com/support
Installation instructions are provided in readme files with the device driver files.
Installing security features
To help prevent hardware theft and unauthorized access to your computer, several
security options are available. In addition to physical locks, unauthorized use of
your computer can be prevented by a software lock that locks the keyboard until a
correct password is typed in.
36
User Guide
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
the sides of the chassis and reconnect the drive cables to the system board.
position.
of the cover engage the rails and push the cover to the closed position until it
snaps into position. If your computer has screws that secure the computer
cover, install the screws.
connectors on the rear of your computer" on page 9.
page 49.
Information about this will come with the CRU or will come a few days
after the CRU arrives.
Advertisement
Table of Contents
