Table of Contents
Advertisement
Figure 16. Removing the hard disk drive
Figure 17. Aligning the pins with the holes in the hard disk drive
24
User Guide
4. Use the blue handle to pivot the hard disk drive and bracket upward, slide
the hard disk drive to the left until it is free from the retaining clips in the
bottom of the chassis, and then completely remove it from the chassis.
5. Disconnect the signal and power cables from the rear of the hard disk drive.
6. To install a new hard disk drive into the blue bracket, flex the bracket and
align pin 1 , pin 2 , pin 3 , and pin 4 on the bracket with the holes in
the hard disk drive. Do not touch the circuit board 5 on the bottom of the
hard disk drive.
Advertisement
Table of Contents
