When Paper Misfeeds; Misfeed Location Indicators; Cautions; Removal Procedures - Olivetti d-Copia 15 Operation Manual

CHAPTER 8 WHEN A PROBLEM OCCURS

2. When paper misfeeds

If a paper misfeed occurs, copying will stop. The Misfeed indicator flashes and a misfeed location indicator lights. Remove the misfed paper by
referring to "(3) Removal procedures", with the main switch in the ON (|) position.

(1) Misfeed location indicators

1 1 1 Misfeed in paper feed section
1 1
2 2 2 Misfeed in left cover (page 8-4) 2 2
3 3 3 Misfeed in DF <optional> (page 8-5) 3 3
4 4 Misfeed in drawer <optional> (page 8-5) 4
4 4

(2) Cautions

WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is a
danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient
care when working in this area, as there is a danger of
getting burned.
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove all loose scraps
from inside the copier, or they could cause misfeed later.
* After misfed paper has been removed, warm-up will begin. The
Misfeed indicator will turn off and the copier will return to the same
settings prior to the misfeed.
8-3

(3) Removal procedures

1 Misfeed in paper feed section 1 1 1 1
Misfeed in drawer
If the misfeed location indicator shown in the illustration below
lights while using the drawer, a misfeed has occurred in the drawer.
Remove the misfed paper using the procedure given below.
1
Open the drawer.