ClockWorks For Mac OS X
CHAPTER 5
OVERVIEW
This chapter provides instructions for running the Mac
OS X version of ClockWorks. If you are running Mac OS 9,
see chapter 6, "ClockWorks for Mac OS 9" (page 53).
About ClockWorks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
The File menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
the Device list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
The Routings tab . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
The Presets tab . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
The Mutings tab. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
The Mappings tab. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40
Sync tab settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
The Pedal tab. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
Future updates. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
ABOUT CLOCKWORKS
ClockWorks is a software program that gives you access to
the programmable features in your MOTU MIDI Express
XT or micro express interface. For example, you can make
changes to the synchronization settings, filter some data
on a particular input or output, or route MIDI data from
any MIDI device to any other MIDI device connected to
your MOTU interface.
☛
ClockWorks cannot be used with a micro lite or
Express 128 interface, as these devices do not support
MIDI processing or synchronization features.
When do you need to use ClockWorks software?
The only time you need to use ClockWorks is when you
would like to make changes to the settings in your MOTU
interface. If all you want to do is use it with a MIDI
sequencer, you don't need to make any changes at all. The
factory settings allow sequencing software to individually
access any of the input or output ports on your MOTU
interface. Just run your sequencer. You only need to run
ClockWorks if you wish to customize your interface
settings.
29