Advertisement
TRUNK DISARM FEATURE
The trunk disarm feature allows the alarm to
disarm automatically whenever transmitter
button 3 is used to activate the trunk release.
This eliminates having to first disarm the alarm
before activating the trunk release. This feature
must be programmed during installation.
CAR LOCATOR FEATURE
The Car Locator feature allows the parking
lights to stay on for 30 seconds instead of
flashing when the alarm is disarmed. This
feature must be programmed during installation
and is not recommended for vehicles with
additional aftermarket or auxiliary lighting.
Remote Start Operation
Important: The system should be placed
into the valet mode when parked inside a
garage or being left for service. Only start
the vehicle in a well ventilated area. Do
not use in a closed garage or indoors. Be
sure to familiarize yourself with all
features prior to using this product.
REMOTE STARTING THE VEHICLE
To remote start the vehicle:
Press button 4 on the transmitter.
• The siren chirps 3 times.
• The parking lights turn on.
• Approximately 2 seconds later the
system will attempt to start the vehicle.
• Once the car has started, the heater or
air conditioner will turn on and run for
the pre-programmed time (15 or 25
minutes). If the engine fails to start on
the first attempt, it will repeat the
starting procedure 2 more times. If the
vehicle fails to start after a total of 3
times the siren will chirp 4 times.
Driving vehicle after Remote Starting:
Unlock the door by pressing button 2 on the
remote transmitter. Enter vehicle, turn
ignition key to the on position (Note: Do not
turn the key all the way to the start position as
you may damage the starter).
Once the ignition key is turned on position,
press the brake pedal and shift the car into
the proper gear and you may now drive the
vehicle (Note: If brake pedal is pressed prior to
turning on ignition, engine will turn off).
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply press
and hold button 4 on the remote transmitter
for three seconds.After the motor has turned
off the doors will relock. This feature must be
programmed during installation.
AUTO COLD START
This feature allows the system to start and
run the vehicle every one or two hours
(selectable by your installer) for a period of
24 hours.This allows the engine to remain at
an operational temperature in extremely
cold weather. Auto Cold Start must be enabled
during installation or it cannot be engaged.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
1. Press and hold the brake pedal.
2. While pressing the brake pedal, press and
hold the Valet switch and transmitter
button 4 for two seconds.
3. Release the brake pedal.
• The parking lights will flash five times.
• The siren will chirp three times.
• The engine will start and run for
thirty seconds to indicate the Cold
Start feature is engaged.
4
Advertisement
