Advertisement
• The doors will unlock.
• The optional illuminated entry feature
will turn on the dome light for 30 seconds.
*
In the event the alarm was triggered while away, the
system will respond with 3 chirps and 3 parking light
flashes.
To enter the Valet Mode:
1. Be sure the system is disarmed.
2. Turn the ignition key on.
3. Press and hold the valet/service
mode switch for 3 seconds.
• The LED will turn on solid indicating
the system is in Valet Mode.
To exit Valet Mode:
1. Turn the ignition key on.
2. Press and hold the valet/service mode
switch for 3 seconds.
• The LED will turn off.
• The Siren will chirp 2 times.
EMERGENCY OVERRIDE
If the transmitter becomes lost or fails to
operate, the system can be disarmed by using
the emergency override feature.
To override the system:
1. Enter the vehicle.
• Because the system is armed, the
siren will sound.
2. Turn on the ignition key.
3. Press the Valet/Service Mode switch.
• The siren will stop sounding.
TRUNK RELEASE
Press button 3 for approx-
imately 2 seconds to open
the trunk.
Remote Start Operation
Important:
into the valet mode when parked inside a
garage or being left for service. Only start
the vehicle in a well ventilated area. Do
not use in a closed garage or indoors.
sure to familiarize yourself with all
features prior to using this product.
REMOTE STARTING THE VEHICLE
To remote start the vehicle:
Press button 2 on the transmitter.
• The siren chirps 3 times.
• The parking lights turn
on.
• Approximately 2
seconds later the
system will attempt
to start the vehicle.
• Once the car has started, the heater or
air conditioner will turn on and run for
the preprogrammed time (15 or 25
minutes). If the engine fails to start on
the first attempt, it will repeat the
starting procedure 2 more times. If the
vehicle fails to start after a total of 3
times the siren will chirp 4 times.
Driving vehicle after Remote Starting:
Unlock the door by pressing button 1 on the
remote transmitter. Enter vehicle, turn
ignition key to the on position (Note: Do not
turn the key all the way to the start position as
you may damage the starter).
Once the ignition key is turned to the on
position, press the brake pedal and shift the
car into the proper gear and you may now
drive the vehicle (Note: If brake pedal is
pressed prior to turning on ignition, engine will
turn off).
Press
2
The system should be placed
Be
Press
Advertisement
