Download Print this page

Ignition Lock - Black Widow Security BW RAS 130 Owner's Manual

Remote start/security system
Hide thumbs Also See for BW RAS 130:

Advertisement

AUTO REARM FEATURE
The Auto Rearm feature allows the system
to automatically re-arm itself in the event the
system is disarmed and a door is not opened
within 30 seconds. This feature must be
programmed during installation.
NOTE: This feature will not work on vehicles
with the illuminated entry feature enabled.
TEMPORARY CHIRP DELETE
To Arm or Disarm the system without
chirps, press button 3. The parking lights will
flash to indicate the setting and the chirps
will be muted.
FULL-TIME CHIRP DELETE
For full time silent operation, the Arm/ Disarm
chirps can be permanently disabled. This feature
must be programmed during installation.

IGNITION LOCK

The ignition locking feature allows the doors
to automatically lock when the ignition key is
turned on, and automatically unlock when
the ignition key is turned off. This feature must
be programmed during installation.
VALET MODE
When the system is placed into the Valet
Mode, both the remote starting feature and
the security system will be disabled.
However, the keyless entry and trunk release
features will still function.
To enter Valet Mode:
1. Turn the ignition key on.
2. Press and hold the valet/service mode
switch for 3 seconds.
• The LED will turn on.
• The Siren will chirp 2 times.
To exit Valet Mode:
1. Turn the ignition key on.
2. Press and hold the valet/service mode
switch for 3 seconds.
• The LED will turn off.
• The Siren will chirp 2 times.
EMERGENCY OVERRIDE
If the transmitter becomes lost or fails to
operate, the system can be disarmed by using
the emergency override feature.
To override the system:
1. Enter the vehicle.
• Because the system is armed, the
siren will sound.
2. Turn on the ignition key.
3. Press the Valet/Service Mode switch for
three seconds.
• The siren will stop sounding.
REMOTE PANIC
In the event of an emergency (PANIC)
situation, the system's siren can be triggered
to attract attention. To activate the Panic
Feature, press transmitter button 1 for 3
seconds:
• The siren will sound .
• The parking lights will flash.
• The horn will honk.
The Panic mode will run for 45 seconds, or
until transmitter button 1 is pressed again.
Also, if the vehicle is Remote Started,
activating the Panic Feature will shut down
the Remote Start.
TRUNK RELEASE
When the optional trunk release feature is
connected, pressing button 3 for 2 seconds
will open the trunk.
3

Advertisement

loading

This manual is also suitable for:

130