Olivetti Fax-Lab 105 Instructions Manual page 39

T
O CHANGE THE REMOTE CONTROL CODE
If the fax machine is connected to an extension that oper-
ates in tone dialling mode and is set up for manual
reception, whenever there is a call from a correspondent
wishing to send you a document, you can set it to receive
the document by typing the code
operation has the same effect as pressing the
the fax machine.
You can replace the second "asterisk" of this code using
digits from 0 to 9.
1. Press the key
until the display shows:
2. Press the key:
The display shows:
3. Press the key
The display shows the line to which the fax machine was set
to be connected, for example:
4. Press the key
until the display shows:
5. Press the key:
The display shows the code you set previously, for ex-
ample:
6. To type the new code, press the keys:
-
7. To confirm the new code, press the key:
8. To return the fax machine to its initial stand-by mode, press
the key:
N O T E
If you want to disable this function, after the fourth step, press the |/}
keys to display: "REMOTE START:OFF", then press the
to confirm and the key to return the fax machine to its initial
stand-by mode.
n O T E
If you are connected to a private line, follow the same procedure until
the display shows "PUBL.LINE (PSTN)", press the |/} keys to dis-
play: "PRIV.LINE (PBX)" and then continue as described in the pro-
cedure.
* *
on the extension. This
key on
key
O
THER USEFUL TRANSMISSION SETTINGS
T
O CHANGE THE POSITION OF YOUR NAME AND FAX
NUMBER
The information in the heading of the document to be sent
(name, fax number, date and time and number of pages)
may be received by your correspondent's fax machine
outside the text area immediately below the top edge of the
sheet or inside the text area, slightly lower down than in the
previous case.
Your fax machine is designed to send this information inside
the text area.
To change the position
1. Press the key
until the display shows:
2. Press the key:
The display shows:
3. Press the key:
The display shows:
4. Press the key
until the display shows:
5. To select the alternative parameter, press the keys:
| }
/ The display shows:
6. To confirm the setting, press the key:
7. To return the fax machine to its initial stand-by mode, press
the key:
T /
O ENABLE DISABLE REPETITION OF A FAILED
TRANSMISSION FROM THE MEMORY
1. Press the key
until the display shows:
2. Press the key:
The display shows:
3. Press the key:
The display shows:
15