Miele Polaris Operating Instructions Manual page 7

The machine is only completely
isolated from the electricity supply
when:
– it is switched off at the wall socket
and the plug is withdrawn, or
– it is switched off at the mains, or
– the mains fuse is withdrawn, or
– the screw-out fuse is removed (in
countries where this is applicable).
This machine must only be con-
nected to the on-site water supply
using a new hose kit. Old hoses must
not be re-used.
Faulty components must only be
replaced by genuine Miele original
spare parts. Only when these parts are
fitted can the safety standards of the
machine be guaranteed.
If the connection cable is faulty it
must only be replaced by a Miele
approved service technician to protect
the user from danger.
Warning and Safety instructions
Use
This equipment may only be used
in mobile installations such as
ships, caravans, aircraft etc. if a risk as-
sessment of the installation has been
carried out by a suitably qualified engi-
neer.
Do not install your washing machi-
ne in rooms where temperatures
below freezing may occur. Frozen ho-
ses may burst or split. The reliability of
the electronic control unit may be im-
paired at temperatures below freezing
point.
Before using the machine for the
first time, check that the transit fit-
tings at the rear of the machine have
been removed (see section on "Installa-
tion"). During spinning, a transit fitting
which is still in place may result in da-
mage to both the machine and adja-
cent furniture or appliances.
In countries where there are areas
which may be subject to infestation
by cockroaches or other vermin, pay
particular attention to keeping the ma-
chine and its surroundings in a clean
condition at all times. Any damage
which may be caused by cockroaches
or other vermin will not be covered by
the guarantee.
7