Pausing A Wash Program; At The End Of A Wash Program - Baumatic BFD40W Instruction Manual

o Press the Start/Reset button and the program indicator light will
start to blink next to the wash program that you have selected.
o After a few seconds, you will hear the appliance begin to fill with
water and the new wash program will start.
o IMPORTANT: You should only change a wash program if the
detergent has not been released into the machine; otherwise
you may get poor wash results.

Pausing a wash program

o If you press the Start/Reset button briefly during a wash
program, then the wash program will pause.
o The program indicator light will stop blinking.
o The dishwasher will make an audible noise once a minute, until
the Start/Reset button is pressed again.
o When the Start/Reset button is pressed again, the originally
selected wash program will restart.

At the end of a wash program

o The program indicator light will stop blinking and remain on;
there will also be an audible signal that sounds for a period of
time.
o Use the ON/OFF button to switch the dishwasher off.
o IMPORTANT: You should leave the appliance for 15 minutes
BEFORE opening the door. This will allow the steam generated
from the final rinse(s) to dry the dishes.
o Carefully open the door of the appliance and leave it ajar for a
few minutes and allow any remaining steam to disperse.
o WARNING: Hot steam may escape when the door is first
opened, so care should be taken.
o Unload the dishwasher; you should take care in case any of the
items are still warm.
o IMPORTANT: If you leave the door of the dishwasher shut and
do not unload the dishwasher for a prolonged period of time,
then you may get water droplets reforming on the washload.
21