Festool DF 700 EQ Instruction Manual page 17

tors influence the dimensional accuracy of manu-
factured dowel holes and dowelling joints.
Creating the DOMINO connection
Proceed as follows to create a DOMINO dowelling
joint:
1. Select a DOMINO dowel and insert the
suitable bit into the DOMINO joining
machine.
2. Set the routing depth.
3. Set the routing height.
4. Adjust the routing angle if necessary.
5. Mark the areas on the workpieces that
belong together [12-1] so that you will
be able to join them correctly again
once you have cut the dowel holes.
12-1
1
1
6. Position the two workpieces to be joined
A against one another and mark the
desired positions of the DOMINO dowels
with a pencil [12-2].
6. Select the required stop pins.
B
7. Set the desired dowel hole width (ade-
quate fit or with 3 mm play).
1
see page
15
14
13
13
12-2
8. Cutting the dowel holes [12]:
– The first dowel hole by attaching the
stop pin to the side edge of the work-
piece.
– The following dowel holes according
to the previously made pencil mark-
ings and the scale of the vision panel
[12-3].
16
14
1
12-3
see page
17