Baby Lock emore BLMR Instruction And Reference Manual page 85

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error Message Probable Cause
Retrieving the pattern
The "Needle Position" button or "Thread Cutter" button was pressed
while the bobbin winder shaft is moved to the right.
A pattern is being saved.
The "Start/Stop" button was pressed when no pattern is selected.
Bobbin thread has run out.
Little bobbin thread remains.
3
When the embroidery unit is attached.
You tried to set a number of characters that will not fit within the frame.
The upper thread has become tangled around the bobbin case, and the
needle is bent and hitting the needle plate, etc., so the machine stops
(refer to page 78).
A card that cannot be used with this product has been inserted, and you
tried to select a pattern from the card.
An embroidery pattern incompatible with this machine was selected.
You try to retrieve a pattern downloaded as one for a different machine.
The combined character pattern is too large for the embroidery frame.
You can rotate the pattern 90 degrees and continue combining
characters.
Transmitting by USB
The machine was turned on before the embroidery unit was attached.
The bobbin winder is winding the bobbin.
Troubleshooting 83