Threading The Needle - Baby Lock emore BLMR Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY
Note
If the presser foot has been lowered and the
shutter is closed, the machine cannot be
threaded. Be sure to raise the presser foot
and open the shutter before threading the
machine. In addition, before removing the
upper thread, be sure to raise the presser foot
and open the shutter.
This machine is equipped with a window
that allows you to check the position of the
take-up lever. Look through this window and
check that the thread is correctly fed through
the take-up lever.
k Pass the thread behind the needle bar thread
guide.
The thread can easily be passed behind the
needle bar thread guide by holding the thread
in your left hand, then feeding the thread with
your right hand, as shown.
1
a Needle bar thread guide
Next, use the needle threader to thread the
needle. Continue with the procedure in
"Threading the needle" (page 34).
34

Threading the needle

This section describes how to thread the needle.
Memo
The needle threader can be used with sewing
machine needles 75/11 through 100/16 for
embroidery.
Thread with a thickness of 130/20 or thicker
cannot be used with the needle threader.
If the needle threader cannot be used, refer
to "Threading the needle manually (without
using the needle threader)" (page 36).
a Pull the end of the thread passed through the
needle bar thread guide to the left, and then
pass the thread through the thread guide disk
from the front.
a Thread guide disk
b Cut the thread with the thread cutter on the
left side of the machine.
1
a Thread cutter
1