Care And Maintenance; Cleaning The Machine Surface; Cleaning The Race - Baby Lock emore BLMR Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX

Care and Maintenance

Simple machine maintenance operations are described below.

Cleaning the machine surface

If the surface of the machine is dirty, lightly soak a
cloth in neutral detergent, squeeze it out firmly, and
then wipe the surface of the machine. After cleaning
it once with a damp cloth, wipe it again with a dry
cloth.
CAUTION
● Unplug the power cord before cleaning
the machine, otherwise injuries or an
electric shock may occur.

Cleaning the race

Embroidery performance will suffer if dust collects in
the bobbin case, therefore, it should be cleaned
periodically.
Turn off the machine.
a
b Unplug the power cord from the power supply
receptacle on the right side of the machine.
CAUTION
● Unplug the power cord before cleaning
the machine, otherwise injuries or an
electric shock may occur.
c Remove the embroidery unit.
74
d Grasp both sides of the needle plate cover, and
then slide it toward you.
a Needle plate cover
The needle plate cover is removed.
e Remove the bobbin case.
Grasp the bobbin case, and then pull it out.
1
a Bobbin case
f Use the cleaning brush or a vacuum cleaner to
remove any lint and dust from the race and
bobbin thread sensor and their surrounding
area.
c
a Cleaning brush
b Race
c Bobbin thread sensor
• Do not apply oil to the
Note
If lint or dust collects on the bobbin thread
sensor, the sensor may not operate correctly.
a
a
b
.
bobbin case