Security - Kyocera G2GO M2000 User Manual

Enable Roaming Call Alert
You can set the phone to warn you before you
answer or place a call while roaming.
Note: Call prompt is disabled when the phone is
in Emergency Mode.
From Roam Call Alert, select Enabled.
The phone emits a distinctive ring to indicate
when you are roaming during a call. To accept
or place a call while roaming, you must press 1.

Security

This section describes the security features on
your phone. You can adjust these features to
prevent access to your personal information. All
security features are shielded by a four-digit
lock code (typically 0000 or the last 4 digits of
your phone number).
Lock Phone
Set Lock Phone
With your phone locked, you can call only
emergency numbers or your service provider's
customer service number. You can still receive
incoming calls.
1. From Security, enter your four-digit lock
code.
2. Select Lock Phone > OK and one of the
following:
– Never leaves the phone always
unlocked.
– On power up locks the phone every
time you turn it on.
– Now locks the phone immediately.
User Guide
Unlock the Phone
1. From the home screen, select Unlock.
2. Enter your four-digit lock code.
Set Limit Calls
You can limit the calls that can be made from
your phone to emergency numbers, your
contacts, and your service provider's numbers.
1. From Security, enter your four-digit lock
code.
2. Select Limit Calls and one of the following:
– No Limit does not limit calls.
– Limit Outgoing limits outgoing calls
while incoming calls still work.
– Limit All limits both incoming and
outgoing calls.
Erase All Contacts
1. From Security, enter your four-digit lock
code.
2. Select Erase Contacts > Yes > Yes to erase
all entries from your contacts list.
Note: You cannot recover deleted information.
Change Lock Code
Change your lock code from the default.
1. From Security, enter your four-digit lock
code.
2. Select New Lock Code > Yes.
3. Enter a new four-digit code.
4. Re-enter your new lock code.
77