Kyocera G2GO M2000 User Manual page 76

Enable Roaming Service Alert
Use this setting if you want the phone to alert
you when you roam outside of your home
service area.
From Roam/Svc Alert, select one of the
following:
• Disabled turns roaming service alert off.
• When no svc alerts you with three tones
decreasing in pitch when service is lost and
three tones increasing in pitch when service
is acquired again.
• On roam change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
• On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones if
the phone loses service.
Set Roaming Restrictions
You can restrict your phone from making a call
when roaming.
From Roam Option, select Automatic (to
allow roaming) or No Roaming (to disallow
roaming).
Set Phone Line
Your phone can have two service accounts, or
phone lines, associated with it. Each phone line
has its own phone number.
Note: You must first establish a second phone
line with your service provider. Once
76
established, a second phone number becomes
available in the menu for selection.
From Set Phone Line, read the note and select
OK and one of the phone lines.
When using one line, you cannot receive calls
from the other. It would be as if the phone were
"off" for that number. Your voicemail, however,
still takes messages. All contacts and settings
are shared for both lines.
Set Location Information
Use Location to share your location
information with network services other than
emergency services (for example, 911, 111, 999
and 000) in serviced areas. This feature works
only when your phone is in digital mode. You
do have the option of turning off the locator to
emergency services.
From Location, select one of the following:
• 911 Only (default) shares your position
information only with emergency services
when you call your 3-digit emergency code.
• Location On shares your position
information, in addition to emergency
services.
Set Web Alerts
You can set an alert to confirm the start or exit
of the browser.
From Web Alert, select one of the following:
• At Start prompts when you start a session.
• At End prompts when you end a session.
• Both prompts when you start and end a
session.
• No Prompts sets for no prompts.
Network