AT&T SPIRIT Attendant Installer's Manual page 38

Printing Call
Processing Reports
Lost Authorized
Caller Code
5. Exit authorized caller mode by dialing
6. To disconnect, dial #.
To print the current settings of call processing options, perform the following
steps:
1. Select an outside line and dial a telephone number that is answered by the
SPIRIT Attendant.
2. Wait for an answer.
3. Dial followed immediately by the authorized caller code and #.
4. Dial 29 followed by the appropriate selection:
5. Dial #.
A single beep will confirm the report has completed.
6. Once the report is completed, exit authorized caller mode by dialing
7. To disconnect, dial #.
If the default authorized caller code (789) is changed and the new code is lost or
forgotten, the default code can be restored. However, this procedure also restores
all the SPIRIT Attendant default settings so that any changed programmed setting
must be reentered and all announcements must be rerecorded.
To restore the default authorized caller code:
1. On the back of the SPIRIT Attendant, set switches 1 and 2 to off (up).
2.
Unplug the SPIRIT Attendant from its power source.
With switches 1 and 2 still off (up), plug the SPIRIT Attendant back into its
3.
power source.
4. Reset switches 1 and 2 to on (down).
5. Dial the default authorized caller code (
Dial 990047 # (the SPIRIT macro code).
6.
7. Use the SPIRIT Attendant Planning Configurator Form to reprogram the
settings and rerecord the announcements.
#.
Day Answer Delay
01 =
Night Answer Delay
02 =
Dialing Delay
03 =
789#).
#.
Testing and Troubleshooting
3-7