Operation - Fujitsu AWTZ14LBC Operating Manual

OPERATION

To Select Mode Operation
Press the necessary Operation button.
Cooling Operation: Press the COOL button (Fig.5 [)
Heating Operation: Press the HEAT button (Fig.5 ])
Dry Operation : Press the DRY button (Fig.5 \)
Auto Operation : Press the AUTO button (Fig.5 a)
Fan Operation : Press the FAN button (Fig.5 b)
The Indoor Unit's OPERATION Indicator Lamp (red) (Fig.2 6) will light.
The Air conditioner will start operating.
Pressing the unit's START/ STOP button (Fig.5 Y) will run the unit in its most
recently-used mode.
To Set the Thermostat
Press the SET TEMP. button (Fig. 5 Z).
: Press to raise the thermostat setting.
: Press to lower the thermostat setting.
●Thermostat setting range:
Cooling/Dry ........................ 18 to 30 °C
Heating ............................... 16 to 30 °C
AUTO .................................. 18 to 30 °C
The thermostat can not be used to set room temperature during the FAN Mode (the
temperature will not appear on the Remote Control Unit's Display).
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 5 g).
Each time the button is pressed, the fan speed changes in the following order:
AUTO
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling : As the room temperature approaches that of the thermostat setting,
the fan speed becomes slower.
Heating : Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the tempera-
ture of the air issued from the indoor unit is low.
Fan : The fan operates at the low speed.
Super Quiet Operation:
Press the SUPER QUIET button(Fig.5 f).
The Indoor Unit's SUPER QUIET Indicator Lamp (green) (Fig.2 7) will light. (No
display on the Remote Control Unit)
SUPER QUIET operation begins.
The Indoor Unit's airflow will be reduced for quieter operation.
● In SUPER QUIET mode, any of the changes listed below will switch SUPER QUIET
Operations off.
• Changing the Fan Speed.
• Switching to HI-POWER Operation.
● When the Air Conditioner's operations are stopped, SUPER QUIET Operation is
cancelled. When the unit is started again, it will run at the Fan Speed displayed
on the Remote Control Unit's FAN CONTROL Display.
● During SUPER QUIET Operation, Heating and Cooling and Dry performance will
be reduced somewhat.
7
Example: When set to COOL
Example: When set to 28°C