Economy Operation; Hi-Power Operation - Fujitsu AWTZ14LBC Operating Manual

ECONOMY OPERATION

Begin Air Conditioner operation before performing this procedure.
Open the Remote Control Unit lid.
To Use the ECONOMY Operation
Press the ECONOMY button (Fig.5 h).
"ECO" appears on the Remote Control Unit display.
Economy operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button (Fig.5 h) again.
"ECO" disappears from the Remote Control Unit display.
Normal operation begins.
About ECONOMY Operation
At the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation for cooling and
heating.
When ECONOMY operation is performed during the cooling mode, dehumidification is improved. This function is especially
convenient when you want to remove the humidity in the room without significantly lowering the room temperature.
During ECONOMY operation, the thermostat setting automatically changes according to the temperature to avoid Unneces-
sary cooling and heating for the most economical operation.
● If the room is not cooled(or heated) well during economy operation, select normal operation.
● Once air conditioner operation is stopped, normal operation begins when the indoor unit is turned on again.
● During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if
ECONOMY operation is selected by pressing the ECONOMY operation button.

HI-POWER OPERATION

Begin Air Conditioner operation before performing this procedure.
Open the Remote Control Unit lid.
To Use the HI-POWER Operation
Press the HI-POWER button(Fig.5 e).
The Indoor Unit's HI-POWER Indicator Lamp (orange) (Fig.2 8) will light.
HI-POWER operation begins.
To Stop the HI-POWER Operation
Press the HI-POWER button(Fig.5 e) again.
The Indoor Unit's HI-POWER Indicator Lamp(orange) (Fig.2 8) will go out.
Normal operation begins.
However, HI-POWER operation will automatically stop under the following conditions.
● If SUPER QUIET Operations are selected during HI-POWER Operation, HI-POWER will be cancelled.
● During cooling mode
The room temperature is 1°C below the thermostat setting or 30 minutes has passed since the HI-POWER operation began.
● During heating mode
The room temperature is 2°C above the thermostat setting.
● During fan mode
15 minutes has passed since the HI-POWER operation began.
About HI-POWER Operation
● During cooling mode
The Indoor unit will operate at maximum power until the room temperature is 1°C below the thermostat setting.
● During heating mode
The Indoor unit will operate at maximum power until the room temperature is 2°C above the thermostat setting.
● During dry mode
The airflow can not be set during HI-POWER operation
● During fan mode
The airflow from the Indoor Unit is increased.
13