Pci/Pnp Setup - ECS IC55H-A Manual

Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
Intel(R) C-STATE tech (Enabled)
C State: CPU idle is set to C2/C3/C4.
ACPI T State (Enabled)
Report processor throttling in ACPI
EUP Support (Enabled)
When enabled, system can not resume by some devices (PCI/PCIE/PME/Ring/RTC,etc)
at S5 state. You can use this item to save power.
Press <Esc> to return to the main menu setting page.

PCI/PnP Setup

This page sets up some parameters for devices installed on the PCI bus and those
utilizing the system plug and play capability.
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
Init Display First
: Move
F1: General Help
Init Display First (PCI)
Use this item to select which graphics controller to use as the primary boot devices.
Press <Esc> to return to the main menu setting page.
PCI/PnP Setup
PCI
Select which graphics
controller to use as
the primary boot
device.
Enter : Select
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Using BIOS
37
Help Item