Installing Memory Modules - ECS IC55H-A Manual

12

Installing Memory Modules

This motherboard accommodates four memory modules. It can support four 240-pin
DDR3 1800 (OC)/1600/1333/1066. The total memory capacity is 16 GB.
DDR3 SDRAM memory module table
Memory module
DDR3 1066
DDR3 1333
DDR3 1600
You must install at least one module in any of the four slots. The total memory
capacity is up to 16 GB.
Do not remove any memory module from its antistatic packaging
until you are ready to install it on the motherboard. Handle the
modules only by their edges. Do not touch the components or metal
parts. Always wear a grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR3 SDRAM .
2 Push the latches on each side of the DIMM slot down.
3 Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
4 Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
5 Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
6 Install any remaining DIMM modules.
Memory Bus
533 MHz
667 MHz
800 MHz
Installing the Motherboard