Warranty - Galaxy DX 29HP Owner's Manual

Fig. 3 Microphone plug pin numbers viewed from rear of pin receptacle.
Be sure that the housing and the knurled ring of Fig. 2 are pushed back onto
the microphone cable before starting to solder. If the washer is not captive to
the pin receptacle body, make sure that it is placed on the threaded portion of
the pin receptacle body before soldering.
If the microphone jack is used to hold the pin receptacle during the soldering
operation, best results are obtained when the connections to pins 1 and 3 are
made first and then the connections to pins 2 and 4. Use a minimum amount
of solder and be careful to prevent excessive solder accumulation on pins,
which could cause a short between the pin and the microphone plug housing.
6. When all soldering connections to the pins of the microphone plug are
complete, push the knurled ring and the housing forward and screw the
housing onto the threaded portion of the pin receptacle body. Note the location
of the screw clearance hole in the plug housing with respect to the threaded
hole in the pin receptacle body. When the housing is completely threaded into
the pin receptacle body, a final fraction of a turn either clockwise or
counterclockwise may be required to align the screw hole with the threaded
hole in the pin receptacle body. When these are aligned, the retaining screw is
then screwed into the place to secure the housing to the pin receptacle body.
7. The two cable clamp retainer screws should now be tightened to secure the
housing to the microphone cord. If the cutting directions have been carefully
followed, the cable clamp should secure to the insulating jacket of the
microphone cable.
8. Upon completion of the microphone plug wiring, connect and secure the
microphone plug in the transceiver.
- 13 -

WARRANTY

This radio is covered by a three year
limited parts and labor warranty.

"Limited" means that we will repair problems caused by factory defects or
normal use at no charge.

Before returning a radio to us for warranty service, please call our Service
Department for a Repair Authorization Number (RAN). This RAN must be
written below your return address on the outside of the shipping box. Boxes
which arrive without a RAN will be refused, and the shipping company will
return the unopened box to you. Be sure to have a pen and paper ready along
with the serial number of your radio before calling. We will give you the RAN
and our shipping address over the phone. The telephone number of the Service
Department is (760) 480-8800, and we suggest calling between 10:00 AM and
4:00 PM Pacific Time.

Please include a note with a detailed description of the symptoms. This is
important because it will help the technician who works on your radio to locate
your problem. Intermittent problems are easily overlooked, so be sure to give
as much detail as possible in your note. Also, please include your telephone
number in case our technicians have any additional questions.

Do not send your bracket, power cord or microphone unless we ask for these
items during our telephone conversation.

You are responsible for getting the radio safely to us. (We suggest using
United Parcel Service.) You must pay to ship the radio to us, and we will pay
to ship the radio back to you. Since we use UPS and they do not ship to Post
Offices boxes, please provide us with a street address for the return of your
radio.

We will repair and return your radio as soon as we can. We appreciate your
choosing a Galaxy radio and we want you to be on the air as much as possible!
Be sure to visit our web site at
www.GalaxyRadios.com
- 14 -