Rs-232 Save / Recall System Configurations - Fluke 8808A User Manual

8808A
Users Manual
Command
REMS
RWLS
LOCS
LWLS

RS-232 Save / Recall System Configurations

Table 4-18 describes RS-232 save/recall system configuration commands, which are used
with the RS-232 interface to set up the remote/local configuration of the Meter.
Command
Save <position>
Call <position>
4-26
Table 4-17. Remote/Local Configuration Commands
Puts the Meter into remote (REMS) state mode without front panel lockout.
r is shown on the display.
Puts the Meter in remote with lockout state (RWLS) with front panel lockout.
r and L are shown on the display. When in RWLS, all front panel
buttons are disabled.
Puts the Meter is local state (LOCS) mode without lockout. All front panel
buttons are enabled.
Puts the Meter in local with lockout state (LWLS) mode. All front panel buttons
are disabled. L is shown on the display.
Table 4-18. Save / Call System Configuration Commands
Saves the current running working status into <position>, where <position> is
1 through 6.
Recalls the working status from <position>, where <position> is 1 through 6.
Description
Description