Using The List Editor - Fluke 8808A User Manual

Using the List Editor

The list editor is used to select the options described in Table 3-7. You may abort an edit
and return to normal operation at any time by pressing Q.
To use the list editor:
1. Select the option list that you want to edit by pressing the applicable button(s) as
indicated in Table 3-7. The option list type is shown in the secondary display and
the associated options are shown in the primary display.
2. Press Uor V to step through the options. (Hold either button to scroll
through the options.) As you step through the list, only the selected option is
shown in normal intensity (bright) while the others are dim.
3. When the desired option is shown, press R to select it. The selected option is
then displayed in normal intensity (bright).
To Set
Touch Hold minimum
response level
RS-232 print-only mode
(if RS-232 interface is
selected)
RS-232 baud rate
Trigger mode
Table 3-7. List Editor Options
Buttons
Q then I
K
Q then K
Data bits
Parity options
Stop bit
Echo mode
Q then J
Operating the Meter from the Front Panel
Options
1 = 5 % of range
2 = 7 % of range
3 = 8 % of range
0,1,2,5,10,20,50,100,
200, 500,1000,2000,
5000,10000,20000, or
50000
300,600,1200,2400,
4800, 9600, or 19200
8
7
E = Even
Odd = Odd
No = None
1
2
On
Off
1, 2, 3, 4, 5
List and Number Editors
Annunciator
HoLd
Print
b a u d
data
Par
StoP
Echo
t r i
3
3-23