M.i.b.ii(Mb Intelligent Bios Ii) - ECS H57H-M Manual

42
M.I.B. II (MB Intelligent BiosII)
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have installed
in your system.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Performance Level
DRAM Frequency
Configure DRAM Timing by SPD
Memory Hole
DRAM Command Rate
CPU Clock Select
CPU Over-clocking Func:
PCIE Over-clocking Func:
Spread Spectrum
Auto Detect DIMM/PCI Clk
Voltage Function
Intel (R) Core (TM) 15 CPU
Ratio Status: Unlocked (Min: 09, Max: 24)
Ratio Actual Value
Intel CPU Clock
Current Memory Frequency : 1333MHz
Meomory Current Type
CPU Vcore
VDIMM
PCH Voltage: 1.032 V
Performance Level (Standard)
This item shows the performance level of the components, the options are: Standard
and Enhanced.
DRAM Frequency (Auto)
This item enables users to adjust the DRAM frequency. The default setting is auto and
we recommend users leave the setting unchanged. Modify it at will may cause the
system to be unstable.
Configure DRAM Timing by SPD (Auto)
When this item is set to enable, the DDR timing is configured using SPD. SPD (Serial
Presence Detect) is located on the memory modules, BIOS reads information coded
in SPD during system boot up.
Memory Hole (Disabled)
This item allows users to enable or disable memory hole remapping.
DRAM Command Rate (Auto)
This item specifies the rate of the DRAM Command.
CPU Clock Select (Auto)
This item allows users to select CPU clock.
CPU Over-clocking Func (Disabled)
This item decides the CPU over-clocking function installed in your system. If the
over-clocking fails, please turn off the system power. And then, hold the PageUp key
(similar to the Clear CMOS function) and turn on the power, the BIOS will recover
the safe default.
M.I.B.II (MB Intelligent BIOS II)
Standard
Auto
Auto
Disabled
Auto
Auto
Disabled
Disabled
Enabled
Enabled
Disabled
650@ 3.20GHz
: 24
: 733MHz
:9-24-9-9-10-100-5-4-5-20
: 1.128 V
: 1.512 V
: Move F10: Save
Enter : Select +/-/: Value
F1:General Help
F9: Optimized Defaults
Using BIOS
Help Item
Options
Standard
Enhanced
ESC: Exit