Power Camera On - Fluke TiR4 User Manual

Power Camera On

With a charged battery inserted, or AC power supply connected, press D as
shown in Figure 1-3. D lights up green, and the start-up screen appears after
approximately 10 seconds.
After powering on your camera, the camera requires a boot up and
warm up period of approximately 30 seconds in order to maintain a
crisp, clear, real-time image. Three minutes after powering on the
camera, the temperature measurement accuracy will be within the
specification requirements.
Because of the thermal mass for the optional 54 mm lens, a warm up
period of 30 minutes is necessary for optimum temperature
measurement.
On/Off
Figure 1-2. Inserting the Battery
Figure 1-3. Turning the Power On and Off
Power Camera On
Note
Note
F2
F3
Introduction
1
eii002.eps
eii003.eps
1-7