Using The Manual Gearbox - Fiat Panda Owner's Handbook Manual

To release the handbrake:
❒ slightly lift the handbrake and press re-
lease button A;
❒ keep button A pressed and lower the
lever. Warning light x will turn off.
Press the brake pedal when carrying out
this operation to prevent the car from
moving accidentally.
USING THE MANUAL
GEARBOX
To engage the gears, press the clutch ped-
al fully and shift the gear lever into one of
the required positions (the diagram is
shown on the knob fig. 2).
IMPORTANT The car can only be put in-
to reverse gear when it has stopped mov-
ing completely. With the engine running,
before engaging the reverse, wait at least
2 seconds with the clutch pedal fully down
to prevent damage and grating of the
gears.
To engage reverse R from neutral, lift the
sliding ring A under the knob and shift the
lever to the right and back.
fig. 2
WARNING
To change gears properly
you must push the clutch
pedal fully down. It is therefore es-
sential that there is nothing under the
pedals: make sure the mats are lying
flat and do not get in the way of the
pedals.
Do not drive with your hand
resting on the gear lever as
the force exerted, even if
slight, could lead over time to
premature wear on the gearbox inter-
nal components.
F0G0060m
105