Fiat Panda Owner's Handbook Manual page 84

WARNING
Make height adjustment
when the car is stationary.
WARNING
After adjustment, always
check that the slider is an-
chored in one of the positions pro-
vided. To do this, with the button A
released, exert a further pressure to
allow the anchor device to catch if re-
lease did not take place at one of the
preset positions.
fig. 3
For certain versions, the front seat belts
have just one fixed anchoring point C-
fig. 3 on the door post.
F0G0195m fig. 4
USING THE CENTRAL SEAT
BELT
Static lap belt with 2 anchor points
(for versions/markets where
applicable) fig. 4
To fasten the seat belt: fit the tongue A
into the buckle B until hearing the locking
click.
To unfasten the seat belt: press button C.
To adjust the belt: run the tape in the
buckle D, pulling the end E ) to tighten and
section F to loosen.
F0G0224m
83