Integrated Peripherals - ECS GF7050VT-M5 Manual

34

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
Onboard IDE Controller
OnChip S-ATA Controller
SATA Mode Select
Onboard Audio Function
Onboard LAN Function
Onboard LAN Boot ROM
USB Controller
Legacy USB Support
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
Onboard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
OnChip S-ATA Controller (Enabled)
This item allows you to enable or disable the onboard SATA controller.
SATA Mode select (SATA Mode)
Use this item to select the mode of the Serial ATA.
Onboard AUDIO Function (Enabled)
Use this item to enable or disable the onboard audio device.
Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
USB Controller (Enabled)
This item enables the USB controller. Leave this at the default "Enabled" if you want
to connect USB devices to your computer.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
Integrated Peripherals
Enabled
Enabled
SATA Mode
Enabled
Enabled
Disabled
Enabled
Enabled
378
ECP
DMA3
IRQ7
: Move Enter : Select
+/-/: Value F10: Save ESC: Exit
F1:General Help
F9: Optimized Defaults
Introducing the Motherboard
Help Item
DISABLED: disables the
integrated IDE Controller.
Enabled: enables the inte-
grated IDE Controller.