Powering On The Router - 3Com 3C13751 Getting Started Manual

3 Set HyperTerminal properties. Select [Properties\Port Settings] in the
Powering on the
Router
Figure 33 Setting serial interface parameters
HyperTerminal to enter the properties setting window. Select the terminal
emulation type to be VT100 or Auto detect, and click <OK> to return to
the HyperTerminal window.
Checking before power-on
Check according to the following items before powering on the router.
Whether the power cord and PGND wire are correctly connected.
■
Whether the voltage of the power supply complies with the
■
requirement of the router.
Whether the console cable is correctly connected, whether the PC or
■
terminal for configuration is open, and whether the settings are done.
WARNING: Before powering on the router, the user should be aware
where the switch of the power supply to the router is located, so that the
power supply can be disconnected in time once accidents occur.

Powering on the router

Turn on the site power.
■
Turn on the power switch of the router.
■
Startup of the Router 5000 45