3Com 3C13701 Installation Manual page 54

54 C 6: R
HAPTER OUTER
M
AINTENANCE
To validate the new baud rate set on the console terminal, you must disconnect and then
reconnect the terminal emulation program.
4 Select [Transfer/Send file...] in the HyperTerminal window. The following window opens:
Figure 39 Send File dialog box
5 In the displayed Send file dialog box, click <Browse...> to select the application
image file to be downloaded, and select XMODEM for the Protocol field. Then click
<Send>. The following interface appears:
6 After completing download, the system begins writing to Flash memory and upon its
completion outputs the following information:
Download completed.
For an 3Com 5000 router, the system also prompts you to select file type upon
completion of downloading.
please select file to be saved as
1. main application file
2. backup application file
3. secure application file
4. cancel downloading
Enter your choice(1-4):
The system starts writing to Flash memory after you enter your choice and displays:
Writing to flash memory...
Please wait,it needs a long time .Please wait...
########################################################
Writing FLASH Success.
Please use 9600 bps.Press <ENTER> key to reboot the system.
Restore the baud rate of the console terminal to 9600 bps as prompted, disconnect the
terminal and dial again. Then, you can see the system boot banner.