Troubleshooting (10/100Base-T); Pserver Setup - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Troubleshooting (10/100Base-T)

PSERVER Setup

SMART
If you cannot get a connection with the Ethernet Interface after
completing the print setup, confirm the following:
•
Have you tried repowering the Ethernet Interface? Wait about a
minute before checking if it has logged in and attached to a
queue.
•
Is the network connector fastened tightly to the unit?
•
Is the Ethernet Interface already servicing a queue on another
file server? If so, it cannot service another file server at the
same time.
•
Is there an available Netware user license for the Ethernet
Interface to utilize while it acts as a PSERVER? Every
PSERVER takes up one user license since it logs in to the
Novell file server.
•
When going through the PSERVER setup steps, did you name
the Ethernet Interface "M_xxxxxx" where "xxxxxx" equals the
last six digits of the Ethernet address? This is the default format
of the unit's name when it is acting as a PSERVER.
NOTE: This "M_xxxxxx" name must have six digits after the "_" so,
•
Has the Ethernet Interface's name been changed from its
default of "M_xxxxxx" and, if so, have you incorporated this
new name into your PSERVER setup?
•
Is there a password set for the print server to utilize when it is
logging in to the file server? Make sure the Ethernet Interface's
PSERVER password matches that of the PSERVER setup, or
set both places to no password.
if necessary, pad out each byte with a zero (0).
PSERVER Setup
169