AudioSource AMP Three Owner's Manual

Stereo power amplifier with internal bridging

Table of Contents

Download this manual

Stereo Power Amplifier with Internal Bridging

Congratulations on your new purchase and welcome to the AudioSource family of satisfied customers.

We trust you will continue to enjoy the value and quality of your AudioSource AMP Three for many years to

come. To ensure the best performance from your unit, please take a few moments to read this manual. Also,

be sure to retain this document for future reference.

Note: If any part of this product is damaged or missing, do not contact your AudioSource dealer. Please call us directly at 800-435-7115.

Using the Controls

Power

This front panel button will manually switch the AMP Three on or off. A multicolored LED indicates its

power status. To use the Auto On feature, leave this front panel switch in the on position.

Speaker Selector

The AMP Three has two pairs of speaker outputs. Press button A to activate the A outputs. Press button

B to activate the B outputs. Both A and B outputs may be used simultaneously, provided the combined

impedance does not fall below 2 ohms.

Note: Before pressing either of the speaker selector buttons, be sure that the level controls are set at the minimum position.

Input Level Controls

These knobs adjust the incoming signal level and thereby act as volume controls. We recommend that these

be set to max and your signal source (receiver, CD player, preamplifier, etc.) be used to adjust the volume.

AMP Three

Owner's Manual

Table of Contents

Do you have a question about the AMP Three and is the answer not in the manual?

Page 1: Using The Controls
To ensure the best performance from your unit, please take a few moments to read this manual. Also, be sure to retain this document for future reference. Note: If any part of this product is damaged or missing, do not contact your AudioSource dealer. Please call us directly at 800-435-7115. Using the Controls Power This front panel button will manually switch the AMP Three on or off.
Page 2: Speaker Terminals
MANUAL/AUTO LINE OUT THRU POWER RIGHT LEFT BRIDGING (MONO) (STEREO) LINE IN Using the Controls (cont.) Manual/Auto Power Switch (Rear Panel) In the Auto mode, the AMP Three will turn on automatically when an input signal is sensed. In the absence of an input signal, the AMP Three will shut down automatically.
Page 3 Stereo Setup In this configuration, the bridging switch is off for stereo operation. Connect the line out jacks from a stereo signal source to the line in jacks of your AMP Three. Next, connect your speakers to the terminals marked Speaker A (observing proper polarity: red for "+", and black for "-").
Page 4: Safety Instructions
Product Servicing In the event that your AMP Three fails to operated properly, please contact the dealer where you purchased the unit. Or you may contact AudioSource directly for further assistance. Printed in Taiwan...