Hayward Aqua Plus® Installation Manual page 21

Base Station
Plug in the pigtail connector from the wireless base station into the "wireless" connector on the main PCB
in the Aqua Plus control unit.
AQL-CHEM ORP and pH Sensing Kit
Plug in the connector from the AQL-CHEM into one of the "COMM" connectors on the main PCB in the
Aqua Plus control unit as shown below.
Flow Switch
Only applicable if the chlorinator function is enabled. The flow switch cable plugs into the Aqua Plus
Control Center at the position shown in the diagram on page 10. Ensure that the connector catch "snaps"
in order to provide a reliable connection.
Turbo Cell
Only applicable if the chlorinator function is enabled. The Turbo Cell should be plugged in after the
Aqua Plus cover panel is put back in place. Refer to page 10 for the location of the connector.
Base Station
(AQL2-BASE-RF)
Tighten nut
Connector for
Base Station
Main PCB
Connector for
AQL-CHEM
18