How To Enter Factory Mode - Pioneer 434CMX - PDP - 43" Plasma Panel Service Manual

1

6.3 HOW TO ENTER FACTORY MODE

For adjustments, it is necessary to enter Service/Factory mode. There are two ways to enter Service/Factory mode: by using
the remote control unit, or by using RS232C commands from your PC.
A
When the unit is in Standby (STB) Mode
• Please refer to the technical document (Service Knowhow)
When the power is on
B
No. Method
Remote
1
When the conventional Service/Factory code (AA5F) is sent, the unit will enter Service/Factory mode.
control unit
2 PC Connect your PC via its RS232C port, and send the FAY command.
C
D
E
F
64
1
2
Procedures
PDP-434CMX
2
3
3
4
4