Pioneer 434CMX - PDP - 43" Plasma Panel Service Manual page 149

5
CONNECTION PANEL (PLASMA DISPLAY SECTION)
SPEAKER
R
8 ~16
+ ñ
1
Plasma Display Section
The plasma display is provided with 2 video input connectors, 1 video output connector, audio input/output jacks and
speaker terminals.
When this option video card is installed on a plasma display, an additional three sets of video input connectors are
provided (total five), together with one additional video output connector (total two). (Refer to the following page.)
1 SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker that has an impedance of 8 -16 Ω.
2 COMBINATION IN/OUT
Never connect any component to these connectors
without first consulting your Pioneer installation
technician.
These connectors are used in the factory setup.
3 RS-232C
Never connect any component to this connector without
first consulting your Pioneer installation technician.
This connector is used in the factory setup.
4 ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from the
connected component.
Note: Component signals are supported only when a video
card is installed.
5 ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use the ANALOG RGB OUT (INPUT1) terminal to output
the video signal to an external monitor or other
component.
Note: The video signal will not be output from the
ANALOG RGB OUT (INPUT1) terminal when the main
power of this unit is off or in standby mode.
5
6
POWER
OFF
0
~
IN OUT
RS-232C
COMBINA TION
3
2
6 AUDIO (INPUT1) (Stereo mini jack)
7 DIGITAL RGB (INPUT2) (DVI-D jack)
8 AUDIO (INPUT2) (Stereo mini jack)
9 AUDIO (OUTPUT) (Stereo mini jack)
0 MAIN POWER switch
- AC IN
= SPEAKER (L) terminal
PDP-434CMX
6
7
AC IN
ON
-
INPUT1
ANALOG RGB IN ANALOG RGB OUT
D-Sub D-Sub
AUDIO
5
4 6
Use to obtain sound when INPUT1 is selected.
Connect the audio output jack of components connected
to INPUT1 to this unit.
Use to connect a computer.
Note: This unit does not support the display of
copyguard-protected video signals.
Use to obtain sound when INPUT2 is selected.
Connect the audio output jack of components connected
to INPUT2 to this unit.
Use to output the audio of the selected source
component connected to this unit to an AV amplifier or
similar component.
Use to switch the main power of the unit on and off.
Use to connect a power cord to an AC outlet.
For connection of an external left speaker. Connect a
speaker that has an impedance of 8 -16 Ω.
7
8
SPEAKER L
8 ~16
+
=
INPUT2 OUTPUT
DIGITAL RGB AUDIO AUDIO
DVI-D
7 8 9
149
8
A
B
C
D
E
F