Actron CP9180 Manual page 76

Vehicle Diagnostics
From OBD II Function List:
1. Select Record Data.
•Use
key until Record Data is
highlighted.
•Press
✓
Follow all instructions on display.
✓
The ScanTool can maintain only one recording. Make sure to
thoroughly review old recording before erasing.
✓
If a recording currently exists in
4 4
memory, a message prompting to
erase data is displayed.
✓
Scan Tool validates list of global PIDs from vehicle.
2. Refer to View Data to setup Custom List or View Entire List.
✓
There are 2 types of trigger methods used:
Manual Trigger - allows operator to use the
❒
start recording.
Trigger On Codes - automatically triggers when a diagnostic
❒
trouble code (DTC) is detected by vehicle.
4 – 30 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
UP or DOWN arrow
ENTER.
OBD II Function List
=====================
O2 Monitor Test
Diag Monitor Tests
On-Board Systems
Record Data
Vehicle Information
Modules Present
Review Data
MIL STATUS #1
ABSLT TPS
ENG SPEED #2"
CALL LOAD
MAP #4
COOLANT #3
IAT
IGN ADVANCE
ENTER key to