Table of Contents
Advertisement
UNIX Configuration
Using the Installation Shell Script
The installation shell script helps with the setup process. The installation shell
script automates some of the tasks in configuring /etc/hosts, /etc/printcap, and
1
in creating the spool directory for BSD UNIX, and in running the lpadmin com-
mand for System V UNIX.
Preparation
The installation shell script can be used on the following three kinds of work-
stations. This installation shell script cannot be used with other types of work-
stations.
• Solaris 2.5.1, 2.6, 7, 8
• HP-UX 8.x, 9.x, 10.x, 11.0
• Red Hat Linux 6.x, 7, 7.1, 7.2
Depending on the security setting when installed, rsh/rcp/% telnet may not
be usable with RedHat 7.1 or later. Change the security level to the level that
allows use of rsh/rcp/% telnet. For more information about how to change
the setting, see the operating instructions for RedHat.
When you use NIS (Network Information Service) or DNS, you should con-
figure the server before running this installation shell script.
For more information about the configuration utility of your OS, see the man-
ual that comes with the utility.
Assigning the IP Address
Preparation
Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol on the machine is set to active. (The
default is active.)
• Assign an IP address to the machine and configure the other settings re-
quired for using the TCP/IP protocol.
Reference
For more information about how to make the above settings, see the Printer
Reference.
4
Hide quick links:
Advertisement
Table of Contents
