Checking & Maintaining Your Smoke Alarm System - Ei Electronics Ei168RC User Manual

B16014-R0-Ei168RC-U&C 25/7/07 1:13 PM Page 14
(ii) Receivers may be blocked by radio signals occurring on or near their operating
frequencies, regardless of the House Coding.
The Ei168RC RadioLINK Base has been tested to EN 300 220-1 V1.3.1 (2000-
09) in accordance with the requirements of EN 300 220V1.1.1 (2000-09). These
tests are designed to provide reasonable protection against harmful interference in
residential installations. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause interference to radio and/or television reception.
However, there is no guarantee that interference will not occur in a particular
installation. If this device does cause such interference, which can be verified by
turning the RadioLINK device on and off (remove both the mains and turn off back-
up power supplies), the user is encouraged to eliminate the interference by one or
more of the following measures:
(i) Re-orientate or re-locate the unit.
(ii) Increase the distance between the Ei168RC and the device being affected.
(iii) Connect the device being affected to a mains outlet on a circuit different from
the one that supplies the Ei168RC.
(iv) Consult the supplier or an experienced radio/television technician.
7. CHECKING & MAINTAINING YOUR ALARM SYSTEM
7.1 Inspection & Testing Procedure
We recommend that your Alarm System is checked directly after installation and
14