Setting The Atr120; Programming Hints - Acroprint ATR120 User Manual

To open the front
cover, turn the clock
on its back and
remove the two
outer screws on
bottom of clock.
Stand the clock
upright with the back facing you. With both thumbs press down on IN1 and OUT3
buttons while using your fingers to push cover away.
The clock dial panel is shipped locked into place. You have the option of removing
the tab that locks the clock panel into place for easy access when setting the clock. If
you remove the locking tab, we suggest you keep the tab. To remove the locking tab,
unfasten the screw located in the front cover and remove the screw and clip. The
screw and clip may be stored by securing it into the post screw hole below where it
was removed. It is not necessary to remove the locking tab to install the battery or to
adjust the clock dial time setting.
Once the front cover is open, you will be able to install the battery and to set the
time on the dial. Opening the front cover also allows you to access the ribbon
cassette.
V.

Setting the ATR120

Programming Hints

The ATR120 incorporates features to make the task of time and attendance faster and
easier.
The simplest way to program the ATR120 is to set all of the functions, at one time,
while in the program mode. Although, you may set functions independently it is
recommended that you follow the program sequence.
When programming the time, and the time of day for events to occur, the display
will show time in a 24-hour format (i.e. 3:00 PM will be 15:00).
To place the clock in the program mode, set the program switch located on back of
clock, in the upper left corner from "NOR" to "PRO" (top position). This now
activates the 6 manual card-positioning switches ("IN1", "OUT1", etc.) on top of the
4