Battery Cautionary Instructions; Be-3850 Parts Checklist - Bell Sonecor BE-3850 Installation And Operating Manual

BATTERY CAUTIONARY INSTRUCTIONS

BATTERIES: CAUTION
To reduce the risk of fire or injury to persons, read and follow these instructions:
• For the cordless handset, use only 3.6V 600mAh Nickel-Metal Hydride (Ni-MH),
cordless telephone battery pack PM-38BAT (included).
• Do not dispose of the batteries in a fire. The cells may explode. Check with local codes
for possible special disposal instructions.
• Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if swallowed.
• Exercise care in handling batteries in order not to short the battery with conducting
materials such as rings, bracelets, and keys. The battery or conductor may overheat
and cause burns.
• Do not attempt to rejuvenate the batteries identified for use with this product by
heating them. Sudden release of the battery electrolyte may occur causing burns or
irritation to eyes or skin.
• When inserting batteries into this product, the proper polarity or direction must be
observed. Reverse insertion of batteries can cause charging, and that may result in
leakage or explosion.
• Remove the batteries from this product if the product will not be used for a long period
of time (several months or more) since during this time the battery could leak in the
product.
• Do not store this product, or the batteries identified for use with this product, in high
temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose
of extending shelf life should be protected from condensation during storage and
defrosting.
Batteries should be stabilized at room temperature prior to use after cold storage.
The EPA certified RBRC
(Ni-MH) battery indicates Aastra Telecom is voluntarily participating in an
industry program to collect and recycle these batteries at the end of their
useful life, when taken out of service in the United States or Canada. The
®
RBRC program provides a convenient alternative to placing used Ni-MH
batteries into the trash or the municipal waste stream, which may be illegal in
your area. Please call 1-800-8-BATTERY for information on Ni-MH battery
recycling and disposal bans/restrictions in your area. Aastra Telecom's
involvement in this program is part of our commitment to preserving our
environment and conserving our natural resources.
®
Battery Recycling Seal on the nickel-metalhydride
5

BE-3850 PARTS CHECKLIST

JOHN SMITH
555-555-1212
9:45 10/11 AM # 38 RPT 3
NEW
Talk CID Redial
Delete
Edit Menu Save
Flash Mute MEM
1. Handset 2. Base
5. 10-number
4. AC power adapter
memory card
QUICK START GUIDE
BE-3850
SETTING UP THE BASE
1. Connect the telephone line cord to the "LINE"
jack and to a telephone outlet.
2. Connect the AC power adapter to the 9V DC
jack and to an AC outlet.
Note: Use only the supplied AC power adapter. Do not use any
TEL LINE DATA other AC power adapter. Connect the AC power adapter to a
9VDC
300mA continuous power supply. Place the phone close to the AC
outlet so that you can plug in the AC power adapter easily.
INSTALL THE BATTERY
1. Slide open the battery compartment door on the bottom
of the handset.
2. Plug the battery connector into the 2-pin connector in the
battery compartment, and then insert the battery.
3. Close the battery compartment door and place the
handset on the base unit cradle. You will hear a tone and
the CHARGE LED on the base will illuminate.
4. IMPORTANT: Charge the battery pack for at least 8
hours before using the handset the first time.
MAKING CALLS
1. Pick up the handset and press T.
2. Wait until you hear a dial tone and then dial the number you wish to dial.
3 When you are finished talking, press the T key or place the unit back
into the base to end the call.
Note: The CHARGE light on the base will illuminate when the line is active.
8. Quick start card
9. Belt-Clip
3. Headset
6. 7-foot line
cord for desk use
7. Short line cord for
wall installation
10. Ni-MH battery pack
6