Programming Mode Faq; Frequency - Motorola RDV2020 - RDX VHF - Radio User Manual

• If you 'roll-over' to the beginning at Idle
Programming Mode you will hear a 'chirp' and the
LED Indicator will start blinking green again. All
values that were changed will be automatically
saved.

Programming Mode FAQ

1. I got distracted while programming and
forgot which digit I was programming.
What should I do?
Return to 'Idle' Programming Mode and start
over, as you will not be able to return to the
Programming Mode (the radio does not provide
further way to let you know the specific stage
you are at when programming). Therefore you
can:
• Long press the PTT button. The radio will return
to the 'Idle' Programming Mode or,
• Turn OFF the radio and enter Programming
Mode again (see instructions in the beginning of
this section)
42
English
2. I am trying to program a frequency (or
code) value but the radio would not do it.
It rolled over and took me back to value
'0'.
The radio will not allow you to program any
values that are not available in the frequencies
and codes pool. For example, if you try to
program code 128, the radio would not accept
it, as the maximum value allowed is 122. Same
thing will happen with frequencies. Check the
Frequencies and Codes Charts section to
make sure you are programming a valid
number.
3. I am trying to enter the Programming
Mode but the radio would not do it.
The radio might be locked using the CPS to not
allow Front Panel Programming. To re-enable,
use the CPS.