IBM 88861TU Planning Manual page 103

Serial port
Baud rate
Parity
Stop bits
Port assignments
Table 25. User-configurable advanced management module ports
Default
port
Port name number
HTTP 80
HTTPS 443
Telnet 23
SSH 22
SNMP Agent 161
SNMP Traps 162
FTP 21
FTP Data 20
TFTP 69
SLP 427
Remote Disk 1044
Remote 1045
Disk-On-Card
Storage 1046
Description
Server
Remote KVM 3900
TCP 6090
command
mode
SMASH 50023
command-line
processor
Secure 50022
SMASH
command-line
processor
Port
number Description
Port used for Web server HTTP connection using UDP
Port used for SSL connection using TCP
Port used for the Telnet command-line interface
connection
Port used for the Secure Shell (SSH) command-line
interface connection
Port used for SNMP get/set commands using UDP
Port used for SNMP traps using UDP
Port used for the listen port of the
management-module FTP server.
Port used for the data port of the management-module
FTP server.
Port used for the management-module TFTP server.
Port used for the UDP Service Location Protocol (SLP)
connection
Port used for the advanced management module
remote disk server.
Port used for the management-module remote
disk-on-card server.
Port number for the management-module storage
description server.
Port used for the management-module remote KVM
server.
Port used for IBM Director commands using TCP/IP.
Note: IBM Director might not be able to locate the
advanced management module if this port number is
changed.
Port used for the management-module SMASH
command-line protocol over Telnet.
Port used for the management-module secure SMASH
command-line protocol over SSH.
Appendix B. Configuration planning worksheets
97