Step 4: Attach Power Cable - HP VS160 - StorageWorks DLT Tape Drive Troubleshooting Manual
Hp storageworks dlt vs160 tape drive getting started guide - external model (december 2004)
Hide thumbs
Also See for VS160 - StorageWorks DLT Tape Drive:
- Faq (34 pages) ,
- Getting started manual (44 pages)
Table of Contents
Advertisement
Step 4: Attach power cable
An external HP StorageWorks VS160 tape drive will operate using any voltage in the range
100–240 volts (0.7 A, 50-60 Hz). No adjustment is needed. To connect your tape drive to the
power supply, proceed as follows:
1
Make sure that the tape drive is switched OFF. The power switch is on the rear panel.
2
Plug the power cable securely into the socket on the rear panel of the tape drive. (See Figure 6.)
3
Plug the other end of the power cable into the power outlet.
17
Advertisement
Table of Contents
