Step 4: Connect The Power Cable - HP DAT 40e Getting Started Manual

Step 4: Connect the power cable

An external HP StorageWorks DAT drive will operate using any voltage in the range 100–
240 volts (0.7 A, 50-60 Hz). No adjustment is needed. To connect your drive to the power
supply, proceed as follows:
1 Make sure that the drive is switched OFF (O side down). The power switch is on the rear
panel.
2 Plug the power cable securely into the socket on the rear panel of the drive. (See figure 6.)
3 Plug the other end of the power cable into the power outlet.
17