Related Manuals for Alloy 10/100 Base-TX to 100Base-FX Converter POE Power Provider POE100 Series
Summary of Contents for Alloy 10/100 Base-TX to 100Base-FX Converter POE Power Provider POE100 Series
- Page 1 POE100 Series 10/100 Base-TX to 100Base-FX Converter POE Power Provider Version 1.01 Date: 13 July 2005...
-
Page 2: Model Description
1. Overview The POE Series IEEE 802.3u compliant media converters support two types of media 10/100 Base-TX and 100Base-FX. With LFP (Link Fault Propagation) support it allows the administrator to easily diagnose link faults on their network. If the Copper or Fibre link fails, the converter forces the link status of the connecting device to also fail. -
Page 3: Installing The Converter
3. Checklist Before you start installing the POE converter, please verify that the package contains the following items. The POE100 Series AC Power Cord CD containing this manual Please notify your sales representative if any of the above items are missing or damaged. - Page 4 Fig. 1 View of the POE100 Series Media Converter Fig. 2 Example connection between POE100, PD device and Fibre Cable 100FX Fibre Network Fig. 3 POE100 Series to PD Device or POE Splitter (VOIP Phone) Media Converter VOIP PoE Phone, (PoE PD) or PoE Splitter POE100 Series...
- Page 5 PO E100 Series PO E Po wer Provid er Fig. 4 POE100 Series Media Converter Front Panel Fig. 5 POE100 Series Media Converter Rear Panel Fig. 6 Pairs used for transmitting power over Ethernet Cable. Note: The pins used for delivering power to the Powered Device follow the IEEE 802.3af standard.
- Page 6 5. WDM Single Fibre Model The POE100 Series media converter has an optional Wavelength Division Multiplexing (WDM) Model that can transport bi-directional full duplex signals over a single fibre simultaneously. Single Fibre Model 1310nm Single Mode 20Km 1550nm Single Mode 20Km Note: The 1310nm and 1550nm models must be installed in pairs, i.e., install 1310nm model at one end and the 1550nm model at the other end.
- Page 7 10/100 Switch Fibre Cable ● ● ● Fig. 7 Normal Status via a pair of LFP’s 10/100 Switch Fibre Cable ○ ○ ○ Fig. 8 The Status when Copper Cable A link is broken 10/100 Switch Fibre Cable ○ ○ ○...
- Page 8 7. LED Description The following table describes the LED’s located on the POE100 Series media converter. Colour FX LNK/ACT Green Amber FDX/COL TP LNK/ACT Green TP 100 Green Green Green PoE PSE-TP Green Green 15.4W Green 8. DIP Switch Configuration Fig.
- Page 9 Note: 1. S1-2 and S1-3 will take effect only when S1-1 is set to TP-Force 2. S1-5 must be set to 100FDX for Single Fibre Model 3. S1-6 must be set to POE when you need to supply power to a PD. Warning: When the copper port is set to AUTO and is connected to a device that is forced to 100Mbps FDX, an unknown state may result.
Need help?
Do you have a question about the 10/100 Base-TX to 100Base-FX Converter POE Power Provider POE100 Series and is the answer not in the manual?
Questions and answers