Table of Contents
Advertisement
Operating Your Camera
Notes
• As below, the names of protocol have been changed.
- STW(SPD) → SAMSUNG-T
- SEC → SAMSUNG-E
LANGUAGE : You can select the menu language according to your requirements.
RETURN
: Select this to save the SPECIAL menu settings and return to the MAIN
SETUP menu.
EXIT
Select a desired EXIT mode using the Function Setup switch depending on the camera
purpose.
- SAVE
: Save the current settings and exit the MAIN SETUP menu.
- NOT SAVE : Do not save the current settings and exit the MAIN SETUP menu.
- RESET
: Resets the camera settings to the factory defaults. Communication,
Language and Monitor settings are not initialized.
34
COLOR DOME CAMERA
User Guide
Troubleshooting
If you have trouble operating your camera, refer to the following table.
If the guidelines do not enable you to solve the problem, contact an authorized technician.
● Nothing appears on the screen.
Check that the power cord and line connection between the camera and monitor are
▶
properly connected.
Check that you have properly connected UTP cable or BNC cable to the camera.
▶
▶
Check the pin arrangement for the UTP cable. (TIA/EIA-568B)
● The image on the screen is dim.
▶
Is lens stained with dirt? Clean your lens with soft, clean cloth.
Set the monitor to the proper condition.
▶
▶
If the camera is exposed to very strong light, change the camera position.
● The image on the screen is dark.
Adjust the contrast feature of the monitor.
▶
▶
If you have an intermediate device, set the 75Ω / Hi-z properly.
● The camera is not working properly, and the surface of the camera is hot.
▶
Check that you have properly connected the camera to an appropriate power source.
● The SENS-UP function does not work.
Check that AGC of EXPOSURE SETUP menu is 'OFF'.
▶
Check that SHUTTER of EXPOSURE SETUP menu is 'A.FLK' or 'MANUAL'.
▶
● The Motion Detection function does not work.
Check that MOTION DET of SPECIAL SETUP menu is 'OFF'.
▶
● Color is not correct.
▶
Check the setting of WHITE BAL SETUP menu.
● The screen flickers continually.
▶
Ensure the camera is not pointing towards the sun.
● When coaxial communication is not available.
Make sure that the camera and monitor are installed within the recommended distance.
▶
Use the video amplifier equivalent to coaxitron if the recommended installation distance is exceeded.
▶
● Picture is distorted.
▶
Check the length of the UTP cable (900m(3000ft) or less).
● The camera does not work, and the video feed from the camera is not being
received.
Check the Power Supply to see whether the connection status and pin arrangement for
▶
the camera's UTP cable and the Camera Input UTP cable are normal.
COLOR DOME CAMERA
35
User Guide
Advertisement
Table of Contents
