Samsung SCV-3080 Series User Manual page 29

- LEVEL : Adjust the WDR Brightness by controlling the bar from 1 to 100.
- MODE : Indoor and outdoor backlight conditions are appropriately selected.
- ANTI ROLLING : Rolling caused around a fluorescent lamp is improved.
3. Select a desired mode using the Function Setup switch.
o
BLC : Adjust the area to be enhanced
then adjust the level.
SSDR : Enable the user to change the
level.
Notes
• Because there can be a difference in the effectiveness of HLC according to the amount of
light area in the screen, optimize the installation angle for the best HLC performance.
• When dark, the HLC is only activated when a bright light exceeding a specific size. (In NIGHT
ONLY mode).
• The HLC is not activated in day light or when bright light is not present at night. (In NIGHT ONLY mode).
• When using the WDR function, the shutter is only available with the fixed(---) mode.
• Since the performance of the WDR function may be affected by the area of the bright part of
the screen, optimize the installation angle for the best WDR performance.
• If you increase LIMIT, the screen display may be distorted.
• If you use the VPS (Virtual Progressive Scan) function, the CCD reads differently so you can not
use WDR simultaneously. If you set VPS to ON, WDR will be automatically set to FIXED Mode.
HLC : Enable the user to change the level,
limit, mask color/tone and area.
WDR : Enable the user to change the
limit and level.
29
COLOR DOME CAMERA SCV-3080